W10

Product		Rotation	Inside Diameter	Outer Diameter	Height	Material	Spring	Dust lip	Color	Stock	From price
			312	412	11		Yes	No		1	€ 505,-	Compare		visibility	navigate_next
	Oil Seal		90	110	12	NBR – Nitrile	Yes	No	Black	8	€ 37,48	Compare		visibility	navigate_next
	Oil Seal		295	335	16	NBR – Nitrile	Yes	No	Black	16	€ 504,44	Compare		visibility	navigate_next
	Oil Seal		212.74	264.6	15.87	NBR – Nitrile	Yes	No	Black	0	€ On request	Compare		visibility	navigate_next
	Oil Seal		580	630	22	NBR – Nitrile	Yes	No	Black	0	€ On request	Compare		visibility	navigate_next
	Oil Seal		640	690	22	FPM - VITON	Yes	No	Black	0	€ On request	Compare		visibility	navigate_next
	Oil Seal		540	590	22	FPM - VITON	Yes	No	Black	0	€ On request	Compare		visibility	navigate_next

Oil Seal W10

- Pressure-loadable Oil Seal W10 , with a metal outer jacket, supported by an elastomeric sealing lip

- the sealing lip is clamped between the housing plates

 What are the special features?

- loadable by pressure

- The production is independent

- The inner diameter is from 45 millimeters.

- The outer diameter is from 65 millimeters.

- Inside and outside diameter up to 1200 mm possible

- There are no extra costs if you choose a special size or tolerance

- The housing has a very firm and exact seat through press fit

- Be careful with light metals in the combination with housings

what are the application examples?

- big machines

- general machine building

Materials

Standard materials

Sealing lip, NBR

Housing, unalloyed steel 

Spring, analloyed steel

Special materials

Sealing lip, FKM, Silicone, EPDM

Housing, Rust and acid resistant steel AISI 316L

Spring, Rust and acid resistant steel AISI 316L

Application parameters

The information below is for the standard material combination.

Temperature, -40 tot +100 

Pressure, max 0.05 Mpa

Shaft speed, Max 12 m/s

Mineral oil based lubricants, synthetic lubricants.

When using synthetic lubricants, for which no experience figures are available yet, it is very important to demonstrate compatibility during laboratory tests or during practical test runs.

The different permitted maximum values should always be seen in connection with al the application parameters. The total load on the seal is the combination of individu.

Design information

Shaft

Tolerance, ISO H11

Hardness, 45 HRC

Roughness, 

-Ra= 0,2 - 0,8 μm

-Rz= 1,5 μm

-Rmax= 6,3 μm

Surface finish, free of orientation

Housing bore

Tolerance, ISO H8

Roughness, 

Ra= 0,8 - 3,2 μm 

Rz= 6,3 - 16 μm 

Rmax= ≤ 16 μm

If you want more information, or do you have any questions, feel free to contact us.